Support REPLAY_DATA_INJECTION mode
For test builds only, allow an app to inject sensor data and have that
data forwarded to all active clients of the sensors framework. This
allows replay frameworks to be built for advanced testing of system
behavior.
Bug: 262573975
Test: Run on prod/test builds and verify it only works on the latter
Test: Verify all modes continue to work as expected
Change-Id: I9e9fcb76cbd7ab4bc8eddffc71d60981f50517f4
diff --git a/services/sensorservice/SensorService.h b/services/sensorservice/SensorService.h
index 78df501..64bc377 100644
--- a/services/sensorservice/SensorService.h
+++ b/services/sensorservice/SensorService.h
@@ -102,8 +102,7 @@
// Step Detector etc. Typically in this mode, there will be a client (a
// SensorEventConnection) which will be injecting sensor data into the HAL. Normal apps can
// unregister and register for any sensor that supports injection. Registering to sensors
- // that do not support injection will give an error. TODO: Allow exactly one
- // client to inject sensor data at a time.
+ // that do not support injection will give an error.
DATA_INJECTION = 1,
// This mode is used only for testing sensors. Each sensor can be tested in isolation with
// the required sampling_rate and maxReportLatency parameters without having to think about
@@ -116,10 +115,14 @@
// corresponding parameters if the application hasn't unregistered for sensors in the mean
// time. NOTE: Non allowlisted app whose sensors were previously deactivated may still
// receive events if a allowlisted app requests data from the same sensor.
- RESTRICTED = 2
+ RESTRICTED = 2,
+ // Mostly equivalent to DATA_INJECTION with the difference being that the injected data is
+ // delivered to all requesting apps rather than just the package allowed to inject data.
+ // This mode is only allowed to be used on development builds.
+ REPLAY_DATA_INJECTION = 3,
// State Transitions supported.
- // RESTRICTED <--- NORMAL ---> DATA_INJECTION
+ // RESTRICTED <--- NORMAL ---> DATA_INJECTION/REPLAY_DATA_INJECTION
// ---> <---
// Shell commands to switch modes in SensorService.