diff --git a/src/common/defs.h b/src/common/defs.h
index 6ef929c..4f56794 100644
--- a/src/common/defs.h
+++ b/src/common/defs.h
@@ -320,13 +320,13 @@
 #define EAP_MAX_METHODS 8
 
 enum mesh_plink_state {
-	PLINK_LISTEN = 1,
-	PLINK_OPEN_SENT,
-	PLINK_OPEN_RCVD,
+	PLINK_IDLE = 1,
+	PLINK_OPN_SNT,
+	PLINK_OPN_RCVD,
 	PLINK_CNF_RCVD,
 	PLINK_ESTAB,
 	PLINK_HOLDING,
-	PLINK_BLOCKED,
+	PLINK_BLOCKED, /* not defined in the IEEE 802.11 standard */
 };
 
 enum set_band {
diff --git a/src/common/qca-vendor.h b/src/common/qca-vendor.h
index bac87ed..912d1e1 100644
--- a/src/common/qca-vendor.h
+++ b/src/common/qca-vendor.h
@@ -89,6 +89,32 @@
  * @QCA_NL80211_VENDOR_SUBCMD_DFS_OFFLOAD_RADAR_DETECTED: Event used by driver,
  *	which supports DFS offloading, to indicate a radar pattern has been
  *	detected. The channel is now unusable.
+ *
+ * @QCA_NL80211_VENDOR_SUBCMD_P2P_LISTEN_OFFLOAD_START: Command used to
+ *	start the P2P Listen offload function in device and pass the listen
+ *	channel, period, interval, count, device types, and vendor specific
+ *	information elements to the device driver and firmware.
+ *	Uses the attributes defines in
+ *	enum qca_wlan_vendor_attr_p2p_listen_offload.
+ *
+ * @QCA_NL80211_VENDOR_SUBCMD_P2P_LISTEN_OFFLOAD_STOP: Command/event used to
+ *	indicate stop request/response of the P2P Listen offload function in
+ *	device. As an event, it indicates either the feature stopped after it
+ *	was already running or feature has actually failed to start. Uses the
+ *	attributes defines in enum qca_wlan_vendor_attr_p2p_listen_offload.
+ *
+ * @QCA_NL80211_VENDOR_SUBCMD_SAP_CONDITIONAL_CHAN_SWITCH: After AP starts
+ *	beaconing, this sub command provides the driver, the frequencies on the
+ *	5 GHz band to check for any radar activity. Driver selects one channel
+ *	from this priority list provided through
+ *	@QCA_WLAN_VENDOR_ATTR_SAP_CONDITIONAL_CHAN_SWITCH_FREQ_LIST and starts
+ *	to check for radar activity on it. If no radar activity is detected
+ *	during the channel availability check period, driver internally switches
+ *	to the selected frequency of operation. If the frequency is zero, driver
+ *	internally selects a channel. The status of this conditional switch is
+ *	indicated through an event using the same sub command through
+ *	@QCA_WLAN_VENDOR_ATTR_SAP_CONDITIONAL_CHAN_SWITCH_STATUS. Attributes are
+ *	listed in qca_wlan_vendor_attr_sap_conditional_chan_switch.
  */
 enum qca_nl80211_vendor_subcmds {
 	QCA_NL80211_VENDOR_SUBCMD_UNSPEC = 0,
@@ -171,6 +197,9 @@
 	QCA_NL80211_VENDOR_SUBCMD_TSF = 119,
 	QCA_NL80211_VENDOR_SUBCMD_WISA = 120,
 	/* 121 - reserved for QCA */
+	QCA_NL80211_VENDOR_SUBCMD_P2P_LISTEN_OFFLOAD_START = 122,
+	QCA_NL80211_VENDOR_SUBCMD_P2P_LISTEN_OFFLOAD_STOP = 123,
+	QCA_NL80211_VENDOR_SUBCMD_SAP_CONDITIONAL_CHAN_SWITCH = 124,
 };
 
 
@@ -227,6 +256,43 @@
 	QCA_WLAN_VENDOR_ATTR_ROAM_AUTH_AFTER_LAST - 1
 };
 
+enum qca_wlan_vendor_attr_p2p_listen_offload {
+	QCA_WLAN_VENDOR_ATTR_P2P_LISTEN_OFFLOAD_INVALID = 0,
+	/* A 32-bit unsigned value; the P2P listen frequency (MHz); must be one
+	 * of the social channels.
+	 */
+	QCA_WLAN_VENDOR_ATTR_P2P_LISTEN_OFFLOAD_CHANNEL,
+	/* A 32-bit unsigned value; the P2P listen offload period (ms).
+	 */
+	QCA_WLAN_VENDOR_ATTR_P2P_LISTEN_OFFLOAD_PERIOD,
+	/* A 32-bit unsigned value; the P2P listen interval duration (ms).
+	 */
+	QCA_WLAN_VENDOR_ATTR_P2P_LISTEN_OFFLOAD_INTERVAL,
+	/* A 32-bit unsigned value; number of interval times the firmware needs
+	 * to run the offloaded P2P listen operation before it stops.
+	 */
+	QCA_WLAN_VENDOR_ATTR_P2P_LISTEN_OFFLOAD_COUNT,
+	/* An array of arbitrary binary data with one or more 8-byte values.
+	 * The device types include both primary and secondary device types.
+	 */
+	QCA_WLAN_VENDOR_ATTR_P2P_LISTEN_OFFLOAD_DEVICE_TYPES,
+	/* An array of unsigned 8-bit characters; vendor information elements.
+	 */
+	QCA_WLAN_VENDOR_ATTR_P2P_LISTEN_OFFLOAD_VENDOR_IE,
+	/* A 32-bit unsigned value; a control flag to indicate whether listen
+	 * results need to be flushed to wpa_supplicant.
+	 */
+	QCA_WLAN_VENDOR_ATTR_P2P_LISTEN_OFFLOAD_CTRL_FLAG,
+	/* A 8-bit unsigned value; reason code for P2P listen offload stop
+	 * event.
+	 */
+	QCA_WLAN_VENDOR_ATTR_P2P_LISTEN_OFFLOAD_STOP_REASON,
+	/* keep last */
+	QCA_WLAN_VENDOR_ATTR_P2P_LISTEN_OFFLOAD_AFTER_LAST,
+	QCA_WLAN_VENDOR_ATTR_P2P_LISTEN_OFFLOAD_MAX =
+	QCA_WLAN_VENDOR_ATTR_P2P_LISTEN_OFFLOAD_AFTER_LAST - 1
+};
+
 enum qca_wlan_vendor_attr_acs_offload {
 	QCA_WLAN_VENDOR_ATTR_ACS_CHANNEL_INVALID = 0,
 	QCA_WLAN_VENDOR_ATTR_ACS_PRIMARY_CHANNEL,
@@ -265,12 +331,19 @@
  *	band selection based on channel selection results.
  * @QCA_WLAN_VENDOR_FEATURE_OFFCHANNEL_SIMULTANEOUS: Device supports
  * 	simultaneous off-channel operations.
+ * @QCA_WLAN_VENDOR_FEATURE_P2P_LISTEN_OFFLOAD: Device supports P2P
+ *	Listen offload; a mechanism where the station's firmware takes care of
+ *	responding to incoming Probe Request frames received from other P2P
+ *	Devices whilst in Listen state, rather than having the user space
+ *	wpa_supplicant do it. Information from received P2P requests are
+ *	forwarded from firmware to host whenever the host processor wakes up.
  * @NUM_QCA_WLAN_VENDOR_FEATURES: Number of assigned feature bits
  */
 enum qca_wlan_vendor_features {
 	QCA_WLAN_VENDOR_FEATURE_KEY_MGMT_OFFLOAD	= 0,
 	QCA_WLAN_VENDOR_FEATURE_SUPPORT_HW_MODE_ANY     = 1,
 	QCA_WLAN_VENDOR_FEATURE_OFFCHANNEL_SIMULTANEOUS = 2,
+	QCA_WLAN_VENDOR_FEATURE_P2P_LISTEN_OFFLOAD	= 3,
 	NUM_QCA_WLAN_VENDOR_FEATURES /* keep last */
 };
 
@@ -576,6 +649,25 @@
 	/* 8-bit unsigned value to configure the maximum RX MPDU for
 	 * aggregation. */
 	QCA_WLAN_VENDOR_ATTR_CONFIG_RX_MPDU_AGGREGATION,
+	/* 8-bit unsigned value to configure the Non aggregrate/11g sw
+	 * retry threshold (0 disable, 31 max). */
+	QCA_WLAN_VENDOR_ATTR_CONFIG_NON_AGG_RETRY,
+	/* 8-bit unsigned value to configure the aggregrate sw
+	 * retry threshold (0 disable, 31 max). */
+	QCA_WLAN_VENDOR_ATTR_CONFIG_AGG_RETRY,
+	/* 8-bit unsigned value to configure the MGMT frame
+	 * retry threshold (0 disable, 31 max). */
+	QCA_WLAN_VENDOR_ATTR_CONFIG_MGMT_RETRY,
+	/* 8-bit unsigned value to configure the CTRL frame
+	 * retry threshold (0 disable, 31 max). */
+	QCA_WLAN_VENDOR_ATTR_CONFIG_CTRL_RETRY,
+	/* 8-bit unsigned value to configure the propagation delay for
+	 * 2G/5G band (0~63, units in us) */
+	QCA_WLAN_VENDOR_ATTR_CONFIG_PROPAGATION_DELAY,
+	/* Unsigned 32-bit value to configure the number of unicast TX fail
+	 * packet count. The peer is disconnected once this threshold is
+	 * reached. */
+	QCA_WLAN_VENDOR_ATTR_CONFIG_TX_FAIL_COUNT,
 
 	/* keep last */
 	QCA_WLAN_VENDOR_ATTR_CONFIG_AFTER_LAST,
@@ -602,4 +694,23 @@
 	QCA_WLAN_VENDOR_ATTR_SAP_CONFIG_AFTER_LAST - 1,
 };
 
+/**
+ * enum qca_wlan_vendor_attr_sap_conditional_chan_switch - Parameters for AP
+ *					conditional channel switch
+ */
+enum qca_wlan_vendor_attr_sap_conditional_chan_switch {
+	QCA_WLAN_VENDOR_ATTR_SAP_CONDITIONAL_CHAN_SWITCH_INVALID = 0,
+	/* Priority based frequency list (an array of u32 values in host byte
+	 * order) */
+	QCA_WLAN_VENDOR_ATTR_SAP_CONDITIONAL_CHAN_SWITCH_FREQ_LIST = 1,
+	/* Status of the conditional switch (u32).
+	 * 0: Success, Non-zero: Failure
+	 */
+	QCA_WLAN_VENDOR_ATTR_SAP_CONDITIONAL_CHAN_SWITCH_STATUS = 2,
+
+	QCA_WLAN_VENDOR_ATTR_SAP_CONDITIONAL_CHAN_SWITCH_AFTER_LAST,
+	QCA_WLAN_VENDOR_ATTR_SAP_CONDITIONAL_CHAN_SWITCH_MAX =
+	QCA_WLAN_VENDOR_ATTR_SAP_CONDITIONAL_CHAN_SWITCH_AFTER_LAST - 1,
+};
+
 #endif /* QCA_VENDOR_H */
diff --git a/src/common/wpa_common.c b/src/common/wpa_common.c
index d6295b2..299b8bb 100644
--- a/src/common/wpa_common.c
+++ b/src/common/wpa_common.c
@@ -1184,6 +1184,8 @@
 			"WPA2-PSK" : "WPA-PSK";
 	case WPA_KEY_MGMT_NONE:
 		return "NONE";
+	case WPA_KEY_MGMT_WPA_NONE:
+		return "WPA-NONE";
 	case WPA_KEY_MGMT_IEEE8021X_NO_WPA:
 		return "IEEE 802.1X (no WPA)";
 #ifdef CONFIG_IEEE80211R
diff --git a/src/common/wpa_ctrl.h b/src/common/wpa_ctrl.h
index df26c7b..4dcba81 100644
--- a/src/common/wpa_ctrl.h
+++ b/src/common/wpa_ctrl.h
@@ -228,6 +228,11 @@
 /* parameters: <addr> <result> */
 #define ANQP_QUERY_DONE "ANQP-QUERY-DONE "
 
+#define RX_ANQP "RX-ANQP "
+#define RX_HS20_ANQP "RX-HS20-ANQP "
+#define RX_HS20_ANQP_ICON "RX-HS20-ANQP-ICON "
+#define RX_HS20_ICON "RX-HS20-ICON "
+
 #define HS20_SUBSCRIPTION_REMEDIATION "HS20-SUBSCRIPTION-REMEDIATION "
 #define HS20_DEAUTH_IMMINENT_NOTICE "HS20-DEAUTH-IMMINENT-NOTICE "
 
@@ -271,6 +276,9 @@
 
 #define AP_CSA_FINISHED "AP-CSA-FINISHED "
 
+#define P2P_EVENT_LISTEN_OFFLOAD_STOP "P2P-LISTEN-OFFLOAD-STOPPED "
+#define P2P_LISTEN_OFFLOAD_STOP_REASON "P2P-LISTEN-OFFLOAD-STOP-REASON "
+
 /* BSS Transition Management Response frame received */
 #define BSS_TM_RESP "BSS-TM-RESP "