Make the references to features in the help more consistent. (Sylvain Hitier)
diff --git a/runtime/doc/motion.txt b/runtime/doc/motion.txt
index d3e5eef..8d52966 100644
--- a/runtime/doc/motion.txt
+++ b/runtime/doc/motion.txt
@@ -1010,7 +1010,7 @@
*CTRL-O*
CTRL-O Go to [count] Older cursor position in jump list
(not a motion command). {not in Vi}
- {not available without the +jumplist feature}
+ {not available without the |+jumplist| feature}
<Tab> or *CTRL-I* *<Tab>*
CTRL-I Go to [count] newer cursor position in jump list
@@ -1018,18 +1018,18 @@
In a |quickfix-window| it takes you to the position of
the error under the cursor.
{not in Vi}
- {not available without the +jumplist feature}
+ {not available without the |+jumplist| feature}
*:ju* *:jumps*
:ju[mps] Print the jump list (not a motion command). {not in
- Vi} {not available without the +jumplist feature}
+ Vi} {not available without the |+jumplist| feature}
*jumplist*
Jumps are remembered in a jump list. With the CTRL-O and CTRL-I command you
can go to cursor positions before older jumps, and back again. Thus you can
move up and down the list. There is a separate jump list for each window.
The maximum number of entries is fixed at 100.
-{not available without the +jumplist feature}
+{not available without the |+jumplist| feature}
For example, after three jump commands you have this jump list:
@@ -1106,14 +1106,14 @@
If there is no older change an error message is given.
(not a motion command)
{not in Vi}
- {not available without the +jumplist feature}
+ {not available without the |+jumplist| feature}
*g,* *E663*
g, Go to [count] newer cursor position in change list.
Just like |g;| but in the opposite direction.
(not a motion command)
{not in Vi}
- {not available without the +jumplist feature}
+ {not available without the |+jumplist| feature}
When using a count you jump as far back or forward as possible. Thus you can
use "999g;" to go to the first change for which the position is still