patch 9.0.1753: can't move to last non-blank char
Problem: can't move to last non-blank char
Solution: Make g<end> behave like that
Make it possible to move to last non-blank char on a line
We can distinguish between g0 and g^ to move to the very first character
and the first non-blank char.
And while we can move to the last screen char, we cannot go to the last
non-blank screen char.
Since I think g$ is the more widely used and known movement command (and
g<end> is synonymous to it) change the behaviour of g<end> to move to
last non-screen char instead and don't have this be the same command as
the g$ command anymore.
If you want to keep the old behaviour, you can use:
```
nnoremap g<end> g$
```
Add a test to verify the behaviour.
closes: #12593
Signed-off-by: Christian Brabandt <cb@256bit.org>
diff --git a/runtime/doc/motion.txt b/runtime/doc/motion.txt
index 263c4f3..46f9680 100644
--- a/runtime/doc/motion.txt
+++ b/runtime/doc/motion.txt
@@ -242,8 +242,8 @@
Thus "10gM" is near the start of the text and "90gM"
is near the end of the text.
- *g$* *g<End>*
-g$ or g<End> When lines wrap ('wrap' on): To the last character of
+ *g$*
+g$ When lines wrap ('wrap' on): To the last character of
the screen line and [count - 1] screen lines downward
|inclusive|. Differs from "$" when a line is wider
than the screen.
@@ -255,6 +255,9 @@
instead of going to the end of the line.
When 'virtualedit' is enabled moves to the end of the
screen line.
+ *g<End>*
+g<End> Like |g$| but to the last non-blank character
+ instead of the last character.
*bar*
| To screen column [count] in the current line.