Update documentation files.
diff --git a/runtime/doc/gui.txt b/runtime/doc/gui.txt
index daf1a9a..09a833b 100644
--- a/runtime/doc/gui.txt
+++ b/runtime/doc/gui.txt
@@ -1,4 +1,4 @@
-*gui.txt* For Vim version 7.2. Last change: 2008 Jun 14
+*gui.txt* For Vim version 7.2. Last change: 2009 Jan 22
VIM REFERENCE MANUAL by Bram Moolenaar
@@ -35,13 +35,13 @@
The X11 version of Vim can run both in GUI and in non-GUI mode. See
|gui-x11-start|.
- *gui-init* *gvimrc* *.gvimrc* *_gvimrc*
+ *gui-init* *gvimrc* *.gvimrc* *_gvimrc* *$MYGVIMRC*
The gvimrc file is where GUI-specific startup commands should be placed. It
is always sourced after the |vimrc| file. If you have one then the $MYGVIMRC
environment variable has its name.
When the GUI starts up initializations are carried out, in this order:
-- The 'term' option is set to "builgin_gui" and terminal options are reset to
+- The 'term' option is set to "builtin_gui" and terminal options are reset to
their default value for the GUI |terminal-options|.
- If the system menu file exists, it is sourced. The name of this file is
normally "$VIMRUNTIME/menu.vim". You can check this with ":version". Also
@@ -473,9 +473,11 @@
:let did_install_default_menus = 1
If you also want to avoid the Syntax menu: >
:let did_install_syntax_menu = 1
-If you do want the Syntax menu but not all the entries for each available
-syntax file (which take quite a bit of time to load): >
- :let skip_syntax_sel_menu = 1
+The first item in the Syntax menu can be used to show all available filetypes
+in the menu (which can take a bit of time to load). If you want to have all
+filetypes already present at startup, add: >
+ :let do_syntax_sel_menu = 1
+
<
*console-menus*
Although this documentation is in the GUI section, you can actually use menus